Friday, September 17, 2010

Glass Cross Panel, Day Ten (3)

It has been over a week since I last posted. this is the first opportunity I have had to resume work on this piece. The glass squares have been cut, copper foiled and fitted into the frame. This was the very easy part. It took two hours to get this far. These pieces were merely measured out and cut with my Morton Glass cutting system, using a straight edge and guides. All the pieces were pretty uniform this way and only minimal fitting and grinding was required. All the pieces from here out will need to be traced, cut and fitted. A little more work, but not too much more, I think.

No comments:

Post a Comment